UF/RO membrane expertise
We design ultrafiltration (UF) and reverse osmosis (RO) processes for your raw water and treatment targets, and verify performance at commissioning.
UF/RO membrane systems,
built for your raw water
We design, build and commission in-house, and quote fast, even for small sites.
Precision Membrane Engineering, Field-Optimized Solutions
Fast response, custom builds
We fabricate equipment sized to your capacity and site. Small projects get quick quotes too.
From design to maintenance
Design, fabrication and commissioning are in-house. On-site installation is done with partner contractors, and we support inspections after handover.
Equipment
Built around UF/RO membrane systems, we supply the key equipment a treatment process needs.
Membrane systems (UF/RO)
UF membranes remove turbidity and fine particles. RO membranes separate dissolved salts.
View the VZ3000 UF system- Capacity
- 1-300m³/h
- UF nominal pore size
- 0.01-0.1µm
- RO salt rejection
- Up to 99%
Filtration Sand, multimedia and activated carbon filters remove turbidity, suspended solids and organics.
- Capacity
- 5-500 m³/h
- Filtration rate
- 5-15 m/h
- Type
- Pressure / gravity
Disinfection (UV/chlorine) UV irradiation or hypochlorite dosing inactivates pathogens.
- Capacity
- 1-1,000 m³/h
- UV dose
- 40 mJ/cm² or more
- Residual chlorine
- 0.1-1.0 mg/L controlled
Chemical dosing Storage and metering systems for coagulants, pH adjusters and disinfectants.
- Dosing pump
- Diaphragm metering pump
- Dosing rate
- 0.1-500 L/h
- Storage tank
- 0.2-20 m³
Instrumentation & control PLC/HMI panels and water quality instruments run and monitor the plant automatically.
- Control
- PLC + HMI
- Measured
- Flow, level, pH, turbidity, residual chlorine
- Remote monitoring
- Optional
Figures are representative. Actual values depend on raw water quality, treatment targets and project conditions.
From first review to operation
One point of contact for the whole project.
-
Consulting
We review raw water and targets and propose process options.
-
Process design
Mass balance and equipment sizing define the process.
-
Basic and detail design
P&IDs, layouts and equipment specifications.
-
Fabrication and installation
We fabricate the equipment, then install it with piping, electrical and instrumentation work.
Installed with partner contractors -
Commissioning
Full commissioning verifies design performance, followed by operator training.
-
Maintenance
Scheduled inspections, consumable replacement and operating data review.
Contact us
Share your raw water quality and required capacity. We will review the process and get back to you.
Helpful to include
- Raw water analysis (if available)
- Required capacity (m³/h or m³/day)
- Treated water use and target quality
- Site location and conditions
- eric@iflo.kr
- Phone
- +82 10-9391-1344
- Address
- Room 205, Sihwa Hi-Tech,
242 Seohaean-ro, Siheung-si,
Gyeonggi-do, Republic of Korea